|
Abrasives
for Woodworking
SANDPAPER (Sheets)
 3M
216U FRE-CUT™
GOLD is the longest-lasting,
best cutting sandpaper I've used. Its about the only
dry sandpaper I've found that sands dewaxed shellac
and other hard-to-sand finishes without corning
immediately. (See photo below). It's graded
to tighter particle size deviation tolerances and is
made with modified stearates that do not cause
problems with in-between sanding of water-based
finishes. It leaves no residue which results in a
chalky look or causes problems with finishes. It's
well worth the price and it's one of the most often
used sandpaper in my shop.
NOTE - 216u is "P" graded. To see how this
grading system compares to conventional CAMI graded
paper click
here
9" x 11" Sheets
GRITS
(P Designation)
-
Order in quantities of 10 sheets or sleeves of 50.
80, 100, 120, 150, 180, 220, 240, 280, 320, 360,
400, 500, 600, 800
 This
panel was coated with Oxford Hybrid varnish. After
20 rubs, the traditional stearated sandpaper (3M
Fre-Cut) on the left corned, while the 216U Gold on
the right was clean
"By the
way, I am exceedingly impressed with the new
sandpaper you sent me (216u Fre-Cut Gold). I have
always wished there would be a paper you could dry
sand with that wouldn't immediately fill up with
finish 'corns'. I can't believe how long it lasts!
It is so liberating to be able to see what you're
doing by dry sanding instead of continually drying
off the piece to see if you've accomplished your
goal.
I never
do furniture, only pianos, but I just did a desk
from the mayor's office here and I used the Oxford
Hybrid and before the top coat went on I sanded with
the 800 you sent, and I was astonished at how fast
and how well the job went. At any price, it is a big
time saver and economically a winner. I will be
ordering sleeves of a couple grits very shortly."
Mark Potter - West Jefferson, Ohio
#9080 - 80 grit
10
pk - $12.00
Sleeve/50 -
$48.00
#9100 - 100 grit
#9120 - 120 grit
#9150 - 150 grit
#9180 - 180 grit
#9220 - 220 grit
#9240 - 240 grit
#9280 - 280 grit
#9320 - 320 grit
#9400 - 400 grit
#9500 - 500 grit
#9600 - 600 grit
#9800 - 800 grit
10
pk - $11.25
Sleeve/50 -
$45.00
 3M
7445 White
Scotchbrite Pads - these pads
make their return due to customer request. This is
the least aggressive of all the Scotchbrite products
and are used for blending, light cleaning and
polishing. Also a great way to apply polishes,
waxes, and gel products like stains and gel
finishes.
#7445 - Super fine
grade 6 x 9 pads.
Per pad -
$1.35
Box of 20 - $25.00
 New!
3M
Multi-Flex
Scotchbrite Pads - these
abrasive pads are similar to standard Scotchbrite
pads but are thinner so they are more conformable to
contours. Also much easier to use as they come on a
self dispensing perforated roll so you can tear off
individual 4" x 8" pads. Very handy and much better
for in-between finish sanding. Maroon grade is
approximately 320 grit and similar to 00 grade steel
wool. Ultrafine is approximately 600 grit and
similar to 000 steel wool.
#07521 - Very fine (maroon)
roll 8 in. x 20ft. -
$38.00
#07522 - Ultra fine (gray) roll 8 in. x 20
ft. - $38.00
BACK TO TOP
Copyright © 2010 Homestead
Finishing Products. All rights reserved. |
